HDSM-X Spring Joist Hanger

Joist or wall hanger with 25mm deflection spring element. They can be fitted with a ceiling channel clamp or eye bolt.

HDSM-X Specification:

HDSM-X spring hangers consist of a side attachment steel angle gusseted on each side to prevent bending. The hanger incorporates a steel spring, which can gain circa 25mm of deflection, reaching a natural frequency of 3-5Hz. The metal cup allows for typical drop rod ceiling systems to be installed. Housing configurations offered for simple attachment to 1.5″ x .5″ channels or 12 gauge wire.

Related Products

HDQF-X Spring Hanger

HDQF-X quick fit ceiling hanger (Spring Variant). This hanger has been designed to aid the contractor with a quick and easy installation of suspended acoustic ceilings.

30 Series – Acoustic Spring Hanger

The 30 hanger series can be fitted with a range of springs to suit acoustic and weight requirements. Spring hangers are used to isolate against low frequency noise from sources such as footfalls and mechanical vibration.

30N Series – Spring Hanger

The 30N hanger series can be fitted with a range of springs to suit acoustic and weight requirements. Spring hangers are used to isolate against low frequency noise from sources such as footfalls and mechanical vibration.

HDLP-X Low Profile Ceiling Hanger

The HDLP-A Hanger (PREVIOUSLY CALLED THE CRCH-X) has been designed as a low profile ceiling hanger and is used where floor to ceiling heights are critical. It uses the same spring element as the 30-X and HDQF-X Hanger, and therefore has the same properties.

DNHS – Acoustic Spring Hanger

The DNHS series of hanger features both a metal spring and an LDS rubber element. This provides acoustic isolation against both low and high frequency vibration.

HS – Spring Hanger

The HS series of spring hanger allows for a wide range of springs to be used to suit both acoustic and load requirements.

Spring Hangers

Mason U.K. has a large range of spring hangers available to suit a wide variety of loads and acoustic requirements.